December 9, 2022

Nobody would want to unwind and relax in a tub that has lost its appeal, is damaged, dirty, and in poor condition. But you can easily restore your tub to its former glory via a bathtub reglazing. NY is home to some of the best bathtub reglazing and bathroom refinishing services to help transform your bathroom. Stay on the page to learn more about these services.

Bathtub reglazing is such a great option for your bathroom and tub because it is very economical. Remodeling, replacing, and renovating a bathroom can take a huge chunk of your savings. However, bathtub or bathroom reglazing can be done for a fraction of the price and can successfully give new life to your bathroom.

Reglazing a tub requires careful handling. Damage can still happen even if you work carefully because of poor methods, subpar supplies, or environmental factors. Here, we’ll look at some of the most frequent issues with bathtub reglazing and how to avoid them.

5 Common Bathtub Reglazing Issues and How to Avoid them

Bubbling

When the air becomes trapped between different coating layers, bubbling can develop. It might also occur if the coating was not adequately allowed to cure or if the previous finish was not removed before resurfacing.

Peeling

If there’s a chip on the surface of your reglazed bathtub, peeling may occur, which may cause the entire finish to become loose. This might also happen if the glaze wasn’t fully cured or the surface wasn’t adequately prepped.

Sticky Feel

It is possible for a freshly finished bathtub to feel sticky to the touch if the coating is not fully cured. If this happens, avoid using the tub just yet because it may have to be resprayed.

Chipping

The surface of your freshly reglazed tub can chip if your tub is exposed to a considerable deal of pressure, even if your tub was completely and thoroughly cured. This frequently occurs when you unintentionally drop something heavy upon the bathtub. You can fix this by using a blending solution or by getting in touch with your go-to expert bathtub refinishing company.

Fading

If the refinished coating is blended incorrectly, sprayed too thinly, or both, your reglazed bathtub may start to fade. Your tub’s previous surface will ultimately peek through.

Steps to Avoid Bathtub Reglazing Issues

Prep up the Spot Properly

In order to reglaze a bathtub, strong chemicals are used. As a result, safety has to come first. Use plastic sheeting to completely enclose the bathroom and seal it in place. To ensure the space is properly aired, you should also employ a fan or vent system. Maintaining order in your client’s home throughout the project will result in less cleanup afterward.

Sand off the Previous Finish

The previous finish needs to be completely removed from the bathtub before it can be reglazed. It must first be sanded down to prepare the tub for the new finish.

Repair any cracks, chips, or flaws.

Following the bathtub’s removal from its original materials and sanding, you can find cracks, chips, rust, or other flaws.

Reglaze, Prime, and Coat

Depending on your individual technique, this step might change a little. But typically, a primer is put to the surface and left to completely dry. After that, the glaze is put in several layers. Giving each layer enough time to dry to prevent the bathtub reglazing issues discussed above is crucial. A sealing coat is then applied.

Wrapping Up

With experts like ReglazingPlus doing your job for you, these problems are likely never to occur. Reglazing Plus is one of the best bathtub refinishing companies in NY that has over two decades of experience in the field and several satisfied client testimonials.